The baler has been used in many industries. Some people say that the baler will break down if it is used for a long time, which is actually a very normal phenomenon. Because the baler in the long-term, different environment in the use of the process, mechanical parts wear, gap increases, with the change, directly affect the original balance of the baler, the stability of the baler, reliability, use efficiency will be reduced to varying degrees, or even unable to work normally. Therefore, the maintenance of the baler becomes very important. Through reasonable periodic maintenance, the use efficiency of the baler can be effectively extended.
What are the correct ways to maintain the baler?
1、 At the end of the daily working cycle of the baler, the service condition of the main parts of the baler must be checked. For example, check whether there are chips in the tightening mechanism (the tightening gear plate of the tightening wheel) and the welding cut-off part, and clean them with air gun or brush in time.
2、 Before the rest day of each week, read the manual, understand the lubricating oil filling point of the baler, and focus on filling lubricating oil to lubricate the mechanical relative moving parts of the baler, so as to reduce the wear degree of mechanical parts and increase the service life of the baler.
3、 In the monthly routine inspection of tool use condition, the tool can be disassembled to check the wear condition of internal wearing parts, and the wear degree can be evaluated. For the replacement, those close to replacement should take the initiative to contact our after-sales department to purchase spare parts for replacement.