Portable electric baler can be tightened, welded, cut off button type operation, electric baler compared to more than 100000 automatic packaging equipment, the price is cheap, simple maintenance, and for the manual baler, the price is only a few thousand yuan higher, but it has super efficiency, cost saving, so the choice of portable electric baler is undoubtedly a good choice for major industrial industries. In order to save the maintenance cost of customers and prolong the service life of the machine, Chuangli packaging will give you a detailed answer. What is the reason for the failure of the semi-automatic portable electric packer?
1. The belt feeding length control potentiometer is at the zero position
The solution is to adjust the potentiometer clockwise, the length of the tape will be longer, and the length will be shorter if it is adjusted anticlockwise; If it is in the zero position, there is no tape out.
2. Incorrect wearing
The solution is to open the right door of the machine and pass the belt correctly according to the "threading process method" or threading diagram indicated in the manual.
3. There are foreign matters in the upper and lower extension
Due to the long-term use of the semi-automatic packer, and the failure of timely cleaning and maintenance, there is dirt in the machine, so the belt feeding can not be smooth. The solution to this situation is to do more cleaning and maintenance.
4. The gap of belt feeding roller is incorrect
The gap between a pair of belt feeding rollers of semi-automatic baler plays an important role in normal belt feeding. The adjustment of roller gap refers to the operation manual. The adjustment range of belt feeding roller gap is only 0.05 ~ 1mm more than the belt thickness.
5. The selected pet packing belt is too thin or too thick
At present, there are many pet packing belt manufacturers, the quality of the belt on the market is also good and bad, and the thickness is not consistent, so the packing belt should be selected according to the requirements of the machine. If not, it is necessary to carefully adjust the clearance of the stripper roller according to the instruction manual.
6. The electromagnet is not working properly
The possible reason is that the electromagnet is not working. First of all, check whether the welding joint of the electromagnet connection has fallen off. If not, check whether the coil is burnt out. If there is no problem in both tests, check whether the electromagnet is displaced or blocked by dirt, so that the bullet can not move freely.